Broken Xbox 360 | Fix Broken Xbox 360

How To Fix A Broken Xbox 360 Controller

Sticky buttons on the Xbox 360 controller dead? You can restore that basic with some tools.

There are no more annoying shot or get killed, because dead and missing buttons. Don’t throwing around the room to fix the problem.

To start a screwdriver acquisition. Rotate the controller and remove the seven screws keep together the controller. You, mirror right up and remove the top cover. Don’t panic when everything seems something distant fell.

Remove all buttons and swabs of rubber on which you are seated. It is a good idea to throw on the ground or table, outside what ever you working in the same series as switch in the controller. Makes it easier when trying to understand where is what color. You can also manually invoke a chart before you remove buttons.

Probably, note that the main board and the buttons are permanent. Wash all tablets of rubber in water mild soap. Washing soap works well. If the card is really bad to wash it. If not seem cotton swab and some alcohol so badly can some friction and wipe the contacts were used rubber pads.

Make sure that everything is completely clean and dry. Flip top cover and start replace buttons. It should be made so that a way can go. Next, set the rubber pads again place above the buttons. At this point, you have the inverted head cover.

Install the bottom cover and install the screws. Check the buttons to ensure each move freely. Close it back and now how new should work.